Tilt Doors
Product Summary
- door tiltingWrap-around Construction providing strong and rigid bracing.
- Quality springs for precision, balance and safety.
- Manufactured from Colorsteel® Endura for increased corrosion resistance.
- Anti-sway brackets providing stability.
- Power arms capable of carrying panel weights up to 150kg.
- Engineered pressing, for strength without compromising paint integrity.
- Manual key-locking, positioned for convenience and security.
- Additional security features are available.
- All installation hardware included.
- Suitable for automation with the Garador™ Controll-A-Door™ 4 or Controll-A-Door™ P.
Tilting doors require minimal operating space, with a single, manual door only requiring 25mm headroom. The tilting door has small clearance requirements, with the ability to fit where other garage doors will not.
Size Range
All Garador™ Tilt-A-Dors™ are made to order, up to 2.7m high and 5.1m wide. Maximum height and width combinations will vary depending on the type of material used in construction. Contact your nearest Garador™ dealer for exact Tilt-A-Dor™ size restrictions.
Note: All sizes referred to are Daylight Opening Sizes "DLO". (Finished Trim Sizes) These measurements are the industry standards, and should be the only ones used, as the door is automatically manufactured smaller to fit inside the opening.
Heights
Pricing is based on three heights, 2.260H, 2.400H, & 2.700. The door is manufactured 25mm smaller than the DLO height to allow for operating clearances.
Widths
There are no standard widths. Garador™ tilt doors are manufactured in 1mm increments up to approximately 5.100M wide DLO (Wider sizes are available depending on method of construction and materials used). The door is made 25mm smaller than the DLO width to allow for operating clearances. Pricing starts at the width of 2.400W and is based on 300mm increments up to 5.100W.
Styles
|
Garador Steel Tilt Doors
Colour Range
Garador™ Tilt-A-Dors™ are made from either Zincalume® or Colorsteel® Endura. Both are manufactured by BHP New Zealand Steel Limited, and are commonly used in the roofing and cladding of both residential and commercial buildings... More »
|
| |
Garador Timber Tilt Doors
Garador™ Tilt Doors are also available in TG&V cedar, as well as ply & cedar batten. Both of these options are clad on a welded 25mm x 25mm box section galvanised steel frame, for extra strength and support. The cladding styles available with cedar are virtually endless... More » |
|
PRINTABLE
VERSION
TOP
